您好,欢迎光临莱州聚峰机械有限公司网站! 郑重声明 购机 售后 聚峰官微

全国咨询热线

400-879-1999

您的位置: 首页 > 新闻资讯 > 合作资讯
混凝土搅拌车翻车现象频发是怎么回事?
来源:https://www.cnzkjf.com/ 日期:2020-05-18
  混合车祸中,很大一部分都是事故原因,混凝土搅拌车属于特殊的汽车,它是普通卡车是不一样的,很多人可以驾驶卡车,开车搅拌机还是有点困难的,说次混合机是一种新的上升近十年左右的一种模型,它的是相对较高的,和普通卡车驾驶方法是有区别的。那么混合器翻转的具体原因是什么呢?
  A large part of mixed traffic accidents are caused by accidents. Concrete mixer is a special car. It's different from ordinary truck. Many people can drive trucks, but it's a little difficult to drive mixers. It's said that the first mixer is a new model rising for nearly ten years, left and right. Its center of gravity is relatively high, which is different from ordinary truck driving methods. So what is the specific reason for the mixer turning?
  1. 由于司机操作不当,搅拌车高,搅拌罐在路面上处于恒速旋转状态。在转弯或路况不好的情况下,如果速度和速度控制不好,容易导致搅拌车翻车。
  1. Due to the improper operation of the driver, the center of gravity of the mixer is high, and the mixing tank is rotating at a constant speed on the road. In the case of turning or bad road conditions, if the speed and speed control are not good, it is easy to cause the mixer to overturn.
中科聚峰搅拌车
  2. 糟糕的路况,装有混凝土搅拌机一般从混合站然后运到建筑工地,因为混凝土对环境的污染,因此搅拌装置通常是基于一个相对偏远的地方,所以在一些地方的道路不是很好,混凝土搅拌车车辆荷载,在开车的过程中,路况不好,有点不注意可能会导致一个翻转,如果他们的驾驶技术不熟练,这种路况很好,别接
  2. In poor road conditions, the concrete mixer is usually installed from the mixing station and then transported to the construction site. Because of the pollution of concrete to the environment, the mixing device is usually based on a relatively remote place, so the road in some places is not very good. The load of the concrete mixer truck and vehicle, during the driving process, the road condition is not good, and a little carelessness may lead to a turning over, If their driving skills are not proficient, the road condition is good. Don't take it
  3.如何避免滚转?搅拌机应注意重载时,发动机转速范围内工作1000 - 1400转每分钟,这与大转矩,电动机的交付过程中混凝土、40/小时的速度控制,很大程度上确保运行时,前向速度下降,然后转身在加载混凝土混合料搅拌机,搅拌罐为2 - 10转每分钟的速度,在运输过程中,相对平坦的正面路面搅拌槽转速保持在每分钟2-3转,在路面坡度大于50度时,或从较大路面移动时,搅拌槽应停止转动,待路面条件改善后再恢复转动。
  3. How to avoid rolling? When the mixer is under heavy load, the engine speed range is 1000-1400 rpm, which is in line with the speed control of concrete and 40km / h during the delivery of motor, to a large extent, to ensure that the forward speed drops during operation, and then turns to load the concrete mixer, the mixing tank is 2-10 RPM during transportation, The rotation speed of the mixing tank on the relatively flat front road surface shall be kept at 2-3 revolutions per minute. When the road slope is greater than 50 degrees, or when it moves from the larger road surface, the mixing tank shall stop rotating and resume rotating after the road conditions are improved.