如果混凝土中科搅拌机油雾器中的油面接近油尺下线，我们就需要补充润滑油了，在加油时要注意在没有压力的状态下进行，操作前要将油雾器周围的尘埃杂物清扫干净以免进入油雾器。润滑油普遍选用普通柴油机机油，也可使用粘度为2.5~7度的润滑油或工业用40#机油，贮油杯中的机油要及时更换，一般以油杯容量100毫升计算，使用时长不宜超过100小时；对于油雾器的保养，我们只需要做到定期、及时便可，常见的保养手法例如清洗空气滤清器中的滤芯，滤芯太脏时会导致过滤效果变差，使得进入压缩机气缸中的空气含尘量变高，这会加速气缸和活塞环的磨损速度，并且会形成积垢影响气阀的气密性，严重时甚会导致拉缸、窜气等状况，造成润滑油污染、影响使用效果等，窜气的时候还会出现上油现象，汽缸壁和活塞环的间隙较大，被污染的润滑油会窜入压缩室内形成油雾，污染压缩空气。
If the oil level in the oil sprayer of the concrete Zhongke mixer is close to the bottom line of the oil dipstick, we need to add lubricating oil. When refueling, we should pay attention to carry out under the condition of no pressure. Before operation, the dust and sundries around the oil atomizer should be cleaned to avoid entering the oil mist generator. Ordinary diesel engine oil is generally used as lubricating oil, and lubricating oil with viscosity of 2.5 ~ 7 degrees or industrial 40% engine oil can be used. The oil in the oil storage cup should be changed in time. Generally, the capacity of the oil cup is 100 ml, and the service time should not exceed 100 hours. For the maintenance of the oil mist eliminator, we only need to do regular and timely maintenance. Common maintenance methods such as cleaning the air filter If the filter element is too dirty, the filtering effect will be worse, and the air dust content in the air entering the compressor cylinder will be higher. This will accelerate the wear speed of the cylinder and piston ring, and will form scale, which will affect the air tightness of the gas valve. In serious cases, it will even lead to cylinder pulling, air channeling and other conditions, resulting in lubricating oil pollution, affecting the use effect, etc., and oiling phenomenon will occur when gas channeling The gap between the cylinder wall and the piston ring is large, and the contaminated lubricating oil will rush into the compression chamber to form oil mist and pollute the compressed air.
搅拌站设备停机前，应先卸载然后按次序封闭各部开关和管路，应将螺旋管内的水泥悉数运送出来，搅拌站设备管内不得残留任何物料;冰冻时节，还应放尽水泵、附加剂泵、水箱和附加剂箱内的存水，并应发动搅拌站设备水泵和附加剂泵工作1—2分钟内;搅拌站设备关机后，应把搅拌站设备各个部位都清洗洁净，并保证称量精度。
Before the equipment in the mixing plant is shut down, the switches and pipelines of each part shall be unloaded first, and then all the cement in the spiral pipe shall be transported out, and there shall be no residual materials in the equipment pipe of the mixing station; during freezing, the water stored in the water pump, additive pump, water tank and additive tank shall be drained, and the equipment water pump and additive pump of the mixing station shall be started to work for 1-2 minutes; After the mixing station equipment is shut down, all parts of the mixing station equipment shall be cleaned and the weighing accuracy shall be ensured.
搅拌站设备工作时，贮料区和提升斗下，严禁人员进入;严禁将四肢放入料斗和拌和桶探摸;当拉铲被障碍物卡死时，不得强行起拉，不得用拉铲起吊重物，在拉料过程中，不得进行反转操作;不得超载作业，应查看电动机的工作的状况，当发作声响异常或温度升高时，应立即停机查看;当搅拌站设备满载作业时不得停机，当发作毛病或停电时，应立即切断电源，锁好开关箱，将拌和桶内的混凝土铲除洁净，然后排除毛病或许等待来电。
When the equipment in the mixing plant is working, personnel are not allowed to enter the material storage area and under the lifting bucket; it is strictly forbidden to put limbs into the hopper and mixing bucket to touch; when the dragline is stuck by obstacles, it is not allowed to pull by force or use the dragline to lift heavy objects; in the process of pulling materials, reverse operation is not allowed; It is not allowed to overload operation. Check the working condition of the motor. In case of abnormal sound or temperature rise, stop the machine immediately to check. When the mixing plant is fully loaded, the power supply shall be cut off immediately, the switch box shall be locked, and the concrete in the mixing bucket shall be removed and cleaned, and then the fault shall be eliminated or the power supply may be waiting for power supply.
以上是关于混凝土搅拌机油面接近油尺下线补充润滑油的相关内容介绍，希望对大家有所帮助，如想了解更多内容欢迎点击中科搅拌机官网。
The above is about the concrete mixer oil level close to the dipstick off-line to add lubricating oil introduction, I hope to help you, if you want to learn more, please click the official website of China Science and technology mixer.
