您好,欢迎光临莱州聚峰机械有限公司网站! 郑重声明 购机 售后 聚峰官微

全国咨询热线

400-879-1999

您的位置: 首页 > 新闻资讯 > 合作资讯
混凝土搅拌机运转时出现高温的原因?
来源:https://www.cnzkjf.com/ 日期:2020-08-26
  混凝土搅拌机由于在使用过程中需要不停的开机搅拌难免会出现一些问题,比如温度过高。从生产实践来看,如果发现操作盘上电流表指示的电流,是间断期性的升高,常见的原因是:当设备各部运转正常时,则需查找泥勺头,此时泥勺头很可能松动,勺头松动是造成电流周期性间断升高的主要原因。当然也应该检泥勺底部是否有东西妨碍泥勺旋转。
  Due to the continuous start-up of the concrete mixer in the use process, some problems will inevitably occur, such as high temperature. From the production practice, if it is found that the current indicated by the ammeter on the operation panel increases intermittently, the common reason is that when all parts of the equipment operate normally, it is necessary to look for the mud spoon head. At this time, the mud spoon head is likely to be loose, which is the main reason for the periodic intermittent increase of current. Of course, you should also check if there is something at the bottom of the scoop that prevents it from rotating.
         中科搅拌机
  搅拌机的维护很重要,广大用户一定要根据自己的需要来维护好自己的设备,精益求精是我们对产品质量的不断追求,合理的、优良的服务是与您诚挚合作的前提,如果电流持续升高,不恢复到额定电流,则可能是由于负荷过大或电压低造成的,属于给料量大造成的要调整给料量,属于机械题造成负荷过大,应停车处理。但是如果由电压低造成的,则纯属外部供电原因,积极的办法是勤观察电流有无大的变化和电机温升。
  The maintenance of mixer is very important. The majority of users must maintain their own equipment according to their own needs. Striving for improvement is our constant pursuit of product quality. Reasonable price and excellent service are the premise of sincere cooperation with you. If the current continues to rise and does not return to the rated current, it may be caused by excessive load or low voltage, which belongs to large feeding volume Cause to adjust the amount of feed, belongs to mechanical problems, resulting in excessive load, should stop processing. However, if it is caused by low voltage, it is purely due to external power supply. The positive way is to frequently observe whether the current changes greatly and the motor temperature rise.
  如果突然出现此种现象,往往是由于粒度加大。矿石硬度变化,则可能由于采面不同,配料造成的。出现这两种情况,搅拌过程会引起相应变化。
  If this phenomenon appears suddenly, it is often due to the increase of particle size. The change of ore hardness may be caused by different mining faces and proportioning. In these two cases, the mixing process will cause corresponding changes.