Zhongke Jufeng mixer completes the work of loaders, mixers, transport vehicles and other vehicles in one machine, making it easier to mix concrete. In the face of the concrete residue in the flat mouth mixer, it should be cleaned in time, otherwise it is easy to affect the normal mixing work of the mixer.

1、准备好应急驱动软管，关闭中科聚峰搅拌机，把液压马达上面的高压油管接头拆下。

1. Prepare the emergency drive hose, close the Zhongke Jufeng mixer, and remove the high-pressure oil pipe connector on the hydraulic motor.

2、平口搅拌车停止工作的时候，液压马达的高压油管被拆除，故障车辆上的相应连接器与应急驱动软管进行连接。

2. When the flat mixer truck stops working, the high-pressure oil pipe of the hydraulic motor is removed, and the corresponding connector on the faulty vehicle is connected with the emergency drive hose.

3、启动平口搅拌车并将其手柄转到卸货的位置。故障车辆内的混凝土要及时排出。

3. Start the flat mixer and turn its handle to the unloading position. The concrete in the failed vehicle shall be discharged in time.

4、紧急驱动完成后，拆下驱动软管并恢复搅拌车的原始状态。

4. After the emergency drive is completed, remove the drive hose and restore the original state of the mixer truck.

5、在滚轮和滚道之间放置一个木质楔子，以控制中科聚峰搅拌机的旋转，这个时候一定要注意。关闭发动机并拆下液压马达的高压油管。

5. Place a wooden wedge between the roller and the raceway to control the rotation of zhongkejufeng mixer. Be careful at this time. Shut down the engine and remove the high-pressure oil pipe of the hydraulic motor.

6、控制搅拌筒的旋转，将维护孔转到下面，然后打开维护孔清理缸内混凝土。混凝土卸料后，及时清理搅拌车。

6. Control the rotation of the mixing drum, turn the maintenance hole to the bottom, and then open the maintenance hole to clean the concrete in the cylinder. After the concrete is unloaded, the mixer truck shall be cleaned in time.

需要注意的是，每天收工时完全清洗平口搅拌车及进出料口的周围，保证不沾有水泥及混凝土结块。

It should be noted that at the end of each day, the surrounding of the flat mixer and the inlet and outlet shall be completely cleaned to ensure that there is no cement and concrete caking.