正确的使用自动上料搅拌车有利于施工的顺利进行，并且可以提高工程效率，如果没有正确的使用会损害设备的机械部件，从而减少它的使用寿命。在使用时更重要的是严格按照使用说明来进行操作，一般在夏季如果自动上料搅拌车温度过高时，应该立刻停止工作，等温度降下来之后再继续使用。今天来为大家简单介绍一下自动上料搅拌车的正确使用方法。
The correct use of the automatic feeding mixer is conducive to the smooth construction, and can improve the efficiency of the project. If it is not used correctly, it will damage the mechanical parts of the equipment, thus reducing its service life. It is more important to operate in strict accordance with the instructions when using. Generally, if the temperature of the automatic feeding mixer is too high in summer, it should stop working immediately and continue to use after the temperature drops. Today, let's briefly introduce the correct use of the automatic feeding mixer.
一、备用的散热器有效环境应该保持通风、干燥。不应与任何酸、碱或其他腐蚀性物质接触。
1、 The effective environment of the standby radiator shall be ventilated and dry. It shall not contact with any acid, alkali or other corrosive substances.
二、建议使用软硬水需软化处理后使用，避免造成散热器内部堵塞及水垢的产生。
2、 It is recommended that soft and hard water should be softened before use to avoid blockage and scale inside the radiator.
三、在冬季为防止结冰造成芯子破裂现象，如搅拌车长期停车或间接停车时，应将水箱盖和放水开关，将水全部放出。
3、 In winter, in order to prevent core fracture caused by ice formation, if the mixer truck is stopped for a long time or indirectly, the water tank cover and drain switch shall be used to drain all water.
四、水位计应每3个月清洗一次或视实际情况，各部件拆下用温水加无腐蚀性洗涤剂清洗。
4、 The water level gauge shall be cleaned every 3 months or as the case may be, each component shall be removed and cleaned with warm water and non corrosive detergent.
五、散热器内完全放水再注水时，要先将发动机缸体的放水开关扭开，有水流出时，再关上，从而避免产生水泡。
5、 When the radiator is completely drained and refilled, turn on the water drain switch of the engine block first, and then turn it off when there is water flowing out, so as to avoid water bubbles.
六、在日常使用中应随时检查水位，要停机降温后加水。加水时，将水箱盖慢慢打开，作业人员身体应尽量远离加水口，以防高压蒸汽油加水口喷出造成烫伤。
6、 Check the water level at any time during daily use, and add water after shutdown for cooling. When adding water, slowly open the water tank cover, and keep the operators away from the water inlet as far as possible to prevent scalding caused by the spray of high-pressure gasoline.
The above is a detailed introduction to the Zhongke Self loading Mixer, and I hope it will be helpful to you. If you have any questions, please contact us. We will provide services for you with our attitude https://www.cnzkjf.com
