小型混凝土搅拌机还需怎样来控制速度？
How to control the speed of small concrete mixer?
混凝土搅拌机在使用驾驶中，除脚制动器外，还可以使用油门来控制速度，用油门来控制速度的方法：小型混凝土搅拌机若是出现气缸力小，需要检查气源压力或修理搅拌车的气缸，配料机的进料门工作不正常，供应系统一般具体会出现的问题：主要原因是门和门框之间的间隙太大或门变形。门被沙子和砾石挡住了。纠正材料门或更换材料门或橡胶板。绞车过热主要是由于制动装置间隙不当造成的。发现后立即调整电机制动器。卸下料斗后，无法控制跌落。这主要是由于旅行开关未能修理或更换。.料斗偏向或卡住。这主要是由于两个凸起的芯或芯的跳线长度不一致。可以通过调节灯芯的长度，调节灵敏度的下限和调节防跳装置来。
In addition to the foot brake, the accelerator can also be used to control the speed during the driving of the concrete mixer. The method of using the accelerator to control the speed: if the cylinder force of the small concrete mixer is small, it is necessary to check the air source pressure or repair the cylinder of the mixer, and the feeding door of the batching machine does not work normally, General and specific problems in the supply system: the main reason is that the gap between the door and the door frame is too large or the door is deformed. The door was blocked by sand and gravel. Correct the material door or replace the material door or rubber plate. The overheating of winch is mainly caused by improper clearance of braking device. Adjust the motor brake immediately after discovery. After unloading the hopper, the fall cannot be controlled. This is mainly due to the failure to repair or replace the travel switch The hopper is biased or stuck. This is mainly due to the inconsistency of the jumper length between the two raised cores or cores. It can be solved by adjusting the length of the wick, adjusting the lower limit of sensitivity and adjusting the anti jump device.
混凝土搅拌机在低效区的效果：混凝土搅拌机骨料粉料落入点要求在混凝土搅拌机位置，避开两搅拌轴，严格的管理制度，强大的生产能力和的检测手段，产品质量稳定，主营多种装载机及翻斗车等工程机械，有需要联系我们。
Effect of concrete mixer in low efficiency area: the falling point of aggregate powder of concrete mixer is required to be at the position of concrete mixer, avoiding two mixing shafts, strict management system, strong production capacity and advanced detection means, stable product quality, and mainly engaged in a variety of engineering machinery such as loaders and tippers. If you need to contact us.
小型混凝土搅拌机若是出现气缸力小，需要检查气源压力或修理搅拌车气缸，配料机的进料门工作不正常，供应系统一般具体会出现的问题：在钻孔过程中，塑料渣衬很容易掉入混合器原管道中，所以在操作过程中要多加注意，否则会堵塞末端水点;
If the cylinder force of the small concrete mixer is small, it is necessary to check the air source pressure or repair the cylinder of the mixer truck. The feeding door of the batching machine does not work normally. Generally, there are specific problems in the supply system: during the drilling process, the plastic slag lining is easy to fall into the original pipeline of the mixer, so pay more attention during the operation, otherwise the water point at the end will be blocked;
The above is the detailed introduction of Zhongke mixer. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service https://www.cnzkjf.com
